beautypg.com

ShoreLand'r TA0092 User Manual

Accessory, Ta0092 power winch mounting kit

background image

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028 www.shorelandr.com

0003541

REV A 5/08/06

ACCESSORY

TA0092

Power Winch Mounting Kit

Used on the 6,000 7,000 8,300 9,500 & 15,000 lb. Aluminum Trailers

ASSEMBLY INSTRUCTIONS

Remove the existing winch from the winch post by removing the

bolts securing it to the winch post. These bolts will be replaced with

identical bolts and nuts supplied in the kit.

Remove all items from the box and sort by size.

NOTE: All fasteners supplied are stainless steel. Use an anti-

seeze material on the threads when installing to prevent gauld-

ing of the threads.

NOTE: The two power winch mounting plates are formed and

punched as identical parts. Orient one of them so the holes in it

mate with the holes that attached the original winch just removed

to the winch post. Attach it to the winch post using the new bolts

supplied in the kit similar to those just removed that attached the

winch to the winch post.

Locate the second power winch mounting plate. Position it as shown

mating the holes in the two brackets. Note that the two plates will

be offset from each other by the material thickness of the brackets

because they are identical. Secure the two plates together using ½”

x 1 ½” hex nuts and ½” hex lock nuts.

Place the support straps in position as shown and secure to the two

power winch mounting plates using 3/8” x 1” hex bolts and 3/8” lock

nuts.

They are also identical parts and will be mounted at the

same offset that the power winch mounting plates were.

Do not tighten the bolts at this point because the power winch

bracket may have to be readjusted once the power winch is

installed.

Place the power winch to be installed on the top power winch

mounting plate. Align the holes in the bracket with the mounting

locations on the power winch. Note that there are numerous power

winches on the market and the mounting holes will vary. If the holes

in the power winch mounting plate do not match those of your pow-

er winch, contact your local ShoreLand’r® dealer for the corrective

actions that should be taken to fit your power winch.

Once the proper holes are identified, attach the power winch to the

power winch mounting plate with the ½” x 1 ½” hex bolts and lock

nuts provided.

ADJUSTMENT

The power winch must be setting approximately level when it is be-

ing used. Once the winch post is adjusted so the winch strap is pull-

ing level from the bow eye of the boat, the power winch mounting

bracket can now be adjusted to level out the power winch. Remove

the bottom 3/8” x 1” hex bolts in the support brackets. Rotate the

power winch mounting plate until the power winch is setting level.

When level, align the holes in the support bracket with the closest

hole in the power winch mounting plates. Re-install the bolts just

removed. Then tighten.

Adjustment is complete.

�������

���������������������������������������������������������

����������������������������������������������������

�����������������������

Decal located on power winch bracket: