beautypg.com

ShoreLand'r TA0035 User Manual

Accessory

background image

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0003333

ACCESSORY

TA0035-00

Rear Roller Assembly - 6” Rollers

TA0035-00

REAR ROLLER ASSEMBLY – 6” ROLLERS

The TA0035-00 rear roller assembly is the rear roller assembly for

the SLR83TAL 8,300 lb. capacity trailer. The TA0035-00 is the rear

roller assembly for just one side of the trailer. The same rear roller

assembly can be used on either side of the trailer. Two assemblies

are required to make up the complete roller system for a trailer.

The rollers on the assembly are the patented molded 6”cushion

ShoreLand’r roller.

Installation Instructions

Remove the existing bunk or roller system from the trailer rear cross

member. Place the roller arm into the existing mounting brackets

supplied with the trailer. Align the center hole in the roller arm with

the hole in the mounting bracket, then secure in place using a ½” x

4 ½” hex bolt supplied with the TA0035-00 kit. Secure in place with

a ½” flange lock nut.

Place one of the roller systems onto one end of the mounting arm

just attached. Align the holes and secure to the mounting arm with

another ½” x 4 ½” hex bolt and flange lock nut. Repeat this process

on the roller system on the other end of the mounting bracket.

Tighten all bolts at this time. Assembly is complete.

This manual is related to the following products: