ShoreLand'r SLXR40TCBXLW - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004281
Page 4 of 16 10/28/2010
See Detail A in Diagram A. Secure the tongue cover plate in position
with the same 1/2” x 1-1/2” hex bolt that secures the back on the
tongue to the tongue channel of the frame. Secure with 1/2” lock nut.
Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Push the extra wire provided into the rear
of the tongue or remove the grommet in the side frame and place the
extra wire in the side frame. Replace grommet just removed.
SAFETY CHAINS
Locate the 1/2” x 1-1/4” hex bolt. Slip the bolt through a 1/2” at washer, then
place through the last link of one of the safety chains. Place a second flat
washer on the bolt and insert through the hole as shown in Diagram B. Secure
with a 1/2” flange lock nut. Tighten. Repeat this process on the second safety
chain on the opposite side of the tongue. Assembly is complete.