ShoreLand'r SLV30BSW V.1 - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003430
Page 5 REV A 10/13/06
TONGUE
The tongue is shipped separate of the frame. Locate the
appropriate tongue and install by sliding it in the front of the
tongue channel. Line the holes in the tongue with the holes
in the tongue channel. Install the 1/2” x 4” hex bolt in the
front cross hole and secure with a 1/2” lock nut.
Remove the wire harness from the rear of the tongue. Place
the wire harness and the brake line through the hole pro-
vided in the tongue cover plate. See Detail A in Diagram A.
Secure the tongue cover plate in position with the same
1/2” x 1-1/2” hex bolt that secures the back on the tongue to
the tongue channel of the frame. Secure with 1/2” lock nut.
Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame harnesses
by matching colors and ends. Push the extra wire provided
either into the rear of the tongue or else remove the grom-
met in the side frame and place the extra wire in the side
frame. Replace grommet just removed.
WHITE GROUND WIRE INSTALLATION
Place the self-tapping screw provided through the round
metal ring on the white ground wire of the tongue harness
located at the rear of the tongue. Attach the ground wire to
the main frame by driving the screw in the hole provided
next to the tongue channel of the frame. This will assure a
positive ground for the lighting.
SAFETY CHAINS
Locate the 1/2” x 1-1/4” hex bolt. Slip the bolt through a 1/2”
at washer, then place through the last link of one of the safe-
ty chains. Place a second flat washer on the bolt and insert
through the hole as shown in Diagram B. Secure with a 1/2”
flange lock nut. Tighten.
Repeat this process on the second safety chain on the op-
posite side of the tongue.
Assembly is complete.
BRAKE LINE
Locate the brass brake line coupling. Remove the plastic cap
and thread the brake line coming out the rear of the tongue
into one end of the coupling. Bend the line in a smooth grad-
ual radius being careful not to kink the line. Bend so it can be
mated to the brake line from the side frame. Once aligned,
thread the side frame brake line into the other end of the
coupling. Tighten both lines into the coupling.