ShoreLand'r SLV2313L V.1 - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003385
Page 5 REV A 9/13/06
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, remove
parts and sort by size.
TONGUE
The tongue is shipped separate of the frame. Locate
the appropriate tongue and install by sliding it in the
front of the tongue channel.
Line the holes in the tongue with the holes in the
tongue channel. Install the 1/2” x 4” hex bolt in the front
cross hole and secure with a 1/2” lock nut.
Remove the wire harness from the rear of the
tongue. Place the wire harness and the brake line (If
equipped with brakes) through the hole provided in
the tongue cover plate.
Secure the tongue cover plate in position with the same
1/2” x 1-1/2” hex bolt that secures the back on the
tongue to the tongue channel of the frame. Secure with
a 1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the
extra wire provided either into the rear of the tongue
or else remove the grommet in the side frame and
place the extra wire in the side frame. Replace
grommet just removed.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a
1/2” flat washer, then place through the last link of
one of the safety chains.
Place the bolt with chain attached through the hole
provided in the bottom front of the actuator mount on
the tongue. Place the second chain on the portion of
the bolt extending through the other side of the tongue.
Place on another 1/2” flat washer and hex lock nut.
Tighten.
WINCH POST ASSEMBLY
The height that the bow eye is placed in your boat will
determine the length winch post required. Once this is
determined, attach the winch base to the tongue with
three 1/2” x 4-1/2” carriage bolts and lock nuts.
Align the holes in the Profile 2000 mounting channel
with the holes in the top of the winch base. Attach the
front of the winch head mounting channel to the base by
placing a 1/2” x 4-1/2” hex bolt through the hole closest
to the front of the winch base. Secure with a lock nut.
Do not tighten.
Note that the winch head can now be rotated either up
or down. Identify the correct hole combination to use
to position the bow eye roller just above the bow eye
of your boat. When determined, secure in this position
by placing the bushing as shown in Diagram C inside
the winch base so it aligns with the hole just identified
for the proper adjustment. Insert another 1/2” x 4-1/2”
hex bolt through the determined mounting hole in the
mounting channel and winch base making sure the bolt
passes through the bushing as well. Secure with a 1/2”
lock nut. Tighten all bolts.