ShoreLand'r SLRB55TBBL V.1 - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003482
Page 4
TONGUE
The tongue is shipped separate of the frame. Locate the appropri-
ate tongue and install by sliding it in the front of the tongue chan-
nel.
Locate the rectangular amber side marker lights attached to the
frame. Route the wire harness from the light out the rear of the
tongue. Attach the light to the side of the tongue with the No. 10 x
¾” screw provided. Repeat on the other light.
Locate the wire harness shipped in the hardware bag. Unwind and
insert the two plugs that mate to the frame harness down, then out
the rear of the tongue. Mate the plugs on the end of the wires from
the side marker lights just installed with the single plugs on the
wires at the rear of the tongue harness.
Diagram B
Locate the brake line that is shipped in the brake line box. Uncoil
the line, then route down the inside of the tongue until it comes out
the rear of the tongue.
Align the holes in the tongue with the holes in the tongue channel.
Install the ½” x 4” hex bolt in the front cross hole and secure with a
½” flange lock nut.
Place the wire harness and the brake line through the hole pro-
vided in the tongue cover plate. See Detail A in Diagram A. Secure
the tongue cover plate in position with the same ½” x 1 ½” hex bolt
that secures the back of the tongue to the tongue channel of the
frame. Secure with ½” flange lock nut.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Push the excess wire provided back into
the rear of the tongue.
WHITE GROUND WIRE INSTALLATION
Place the self-tapping screw provided through the round metal ring
on the white ground wire of the tongue harness located at the rear
of the tongue. Attach the ground wire to the main frame by driving
the screw in the hole provided next to the tongue channel of the
frame. This will assure a positive ground for the lighting.
ACTUATOR
Attach the actuator to the tongue with the ½” x 4” hex bolts pro-
vided. Secure with ½” flange lock nuts. Tighten.
Thread the one end of the tongue brake line into the port on the
rear of the actuator. Tighten.
SAFETY CHAINS
Locate the 1/2”x 5” hex bolt. Slip the bolt through a ½” flat washer,
then place through the last link of one of the safety chains. Insert
the bolt into the hole provided in the drop portion of the tongue until
it comes out the hole on the other side of the drop tongue. Place
on a second safety chain, a ½” flat washer, and secure with a ½”
flange lock nut. Tighten.