ShoreLand'r SLR55TCBBS - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004292
Page 4 of 14 11/04/2010
See Detail A in Diagram A. Secure the tongue cover plate in
position with the same 1/2” x 1-1/2” hex bolt that secures the
back on the tongue to the tongue channel of the frame. Secure
with 1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the
extra wire provided into the rear of the tongue or re-
move the grommet in the side frame and place the
extra wire in the side frame. Replace grommet just
removed.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2” flat washer,
then place through the last link of one of the safety chain. Insert
through the hole in the actuator housing and out the other side. Slide
the last link of the other chain over the bolt and slide on a flat washer.
Secure with a 1/2” .flange lock nut. Tighten.
Assembly is complete.