ShoreLand'r SLR46TABBS - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003719
Page 4 11/22/06
TONGUE
The tongue is shipped separate of the frame. Locate the appropri-
ate tongue and install by sliding it in the front of the tongue chan-
nel.
Line the holes in the tongue with the holes in the tongue channel.
Install the 1/2” x 4” hex bolt in the front cross hole and secure with
a 1/2” lock nut.
Remove the wire harness from the rear of the tongue. Place the
wire harness and the brake line through the hole provided in the
tongue cover plate. See Detail A in Diagram A. Secure the tongue
cover plate in position with the same 1/2” x 1-1/2” hex bolt that se-
cures the back on the tongue to the tongue channel of the frame.
Secure with 1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Push the extra wire provided either into
the rear of the tongue or remove the grommet in the side frame
and place the extra wire in the side frame. Replace grommet just
removed.
SAFETY CHAINS
Locate the 1/2” x 1-1/4” hex bolt. Slip the bolt through a 1/2” at
washer, then place through the last link of one of the safety chains.
Place a second flat washer on the bolt and insert through the hole
as shown in Diagram B. Secure with a 1/2” flange lock nut. Tighten.
Repeat this process on the second safety chain on the opposite
side of the tongue. Assembly is complete.
BRAKE LINE
Locate the brass brake line coupling. Remove the plastic cap and
thread the brake line coming out the rear of the tongue into one
end of the coupling. Bend the line in a smooth gradual radius being
careful not to kink the line. Bend so it can be mated to the brake
line from the side frame. Once aligned, thread the side frame brake
line into the other end of the coupling. Tighten both lines into the
coupling.
Diagram B