beautypg.com

ShoreLand'r SLF20BLW User Manual

Page 4

background image

Remove the small parts from the frame by
cutting the bands. Remove the bolt bag and
sort all nuts and bolts by size.

Tongue:

Remove the tongue assembly from the
frame bundle and install into the tongue
channel and secure with a 1/2” X 4” hex bolt
in the side of the tongue and tongue chan-
nel. Secure with a 1/2” flat washer and 1/2”
hex nut.

Place the tongue cover over the rear of the
tongue and tongue channel and secure with
a 1/2” X 1-1/2” hex bolt, 1/2” flat washer and
1/2” hex nut.

Tongue Wires:

Install the tongue wire harness through the
top forward wire hole and exit the rear of the
tongue channel on the frame. Install grom-
mets and plug the tongue wire into the
frame harness by color.

Actuator & Safety Chain:

Slide the actuator into the actuator housing
unit and secure with two (2) pins and snap
rings provided with the actuator. Secure the
actuator-housing unit to the front of the
tongue using three (3) 1/2” X 4” hex bolts
and 1/2” flange lock nuts. Using a 1/2” X 5”
hex bolt on the lower right mounting hole on

the tongue, secure the safety chain. Place a
1/2” flat washer on the 1/2” X 5” hex bolt
followed by one (1) safety chain and insert
into the actuator housing unit and tongue.
Place the second safety chain on the bolt
followed by a 1/2” flat washer and 1/2”
flange lock nut. Tighten.

Brakes:

Refer to the brake manual for service and
maintenance.

Bunks:

Mount the adjustable bunk brackets with the
adjustable bunk clamps to the front
crossmember in a location that would best fit
your watercraft. Secure with 1/2” X 3-9/16” X
3” square u-bolts and 1/2” flange lock nuts.

Mount the short adjustable bunk brackets to
the rear crossmember weldment with the
adjustable bunk clamps. Refer to the parts
drawing for placement. Secure with 1/2” X 3-
9/16” X 4-1/4” square u-bolts and 1/2” flange
lock nuts.

Secure the bunk assemblies to the adjust-
able bunk brackets using 3/8” X 1” hex bolts
and 3/8” flange lock nuts.

DO NOT OVER TIGHTEN - the bunks
must pivot freely to conform to the boats
hull.

This manual is related to the following products: