ShoreLand'r SLB58TCBB - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800-859-3028 www.shorelandr.com 0004215
Page 6 of 13 7/23/2010
RB Bunk Assembly
Locate the support arms
bundle. Place one of the
arms into the factory
installed mounting bracket
on the rear pivot with the
ends curved up as shown.
Secure in the bracket with
two (2) 1/2” x 4” carriage
bolts and hex lock nuts. See
Detail B. Tighten.
Place one of the bunk
assemblies on the end of
the support arms just
installed. Line up the top
hole in the mounting
bracket with the hole in the
support arm and secure
with a 1/2” x 4-1/2” hex
bolts and hex lock nuts.
Tighten. Repeat on the
other end of this support
arm. Repeat this complete
process on the other
support arm.
Note that the bunk
assemblies have two height
adjustments. The
instructions are to install
them in the lowest position
to keep the center of gravity
as low as possible for
towing. If required for fender
clearance, the bunks can be
installed in the raised
position by mounting the
bunk assemblies to the
bunk support arms using
the lower mounting hole.