ShoreLand'r SLB30BXLW - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003437
Page 3
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, remove parts
and sort by size.
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the bunk
mounting brackets are assembled to the bunks at the fac-
tory. Place the end with the two brackets towards the rear of
the trailer. Place the assembly on the equiload bunk arm and
secure by placing a 3/8” x 1” hex bolt through the bracket on
the bunk and the ear on the end of the equiload arm. Secure
in place using a 3/8” lock nut. Repeat on the other end of the
arm. (See Diagram A).
Place the other end of the bunk in the bracket installed on the
front cross member. Note that this bracket is not attached to
the bunk because the trailer can be adjusted to two different
lengths. Once the proper position for the rear crossmember
is determined, the front of the bunk can now be attached to
the bracket using two- No. 10 x 1-1/4” self tapping screws as
shown in Detail B.
The 3/8” x 1” bolts attaching the bunks to the equiload arms
and front bunk bracket can be tightened but not over tight-
ened.
The bunks must be allowed to rotate slightly to conform to
the boat bottom once the boat is set on the
trailer.