ShoreLand'r SLB10 V.1 - Manual (Page 6)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003622
Page 6 REV C 01/25/2008
BUNK BRACKETS & BUNKS
Locate the bunk brackets. See Diagram A. Note that the front bunk
brackets are located on the front of the crossmember while the rear
bunk brackets are located on the rear of the cross member. Choose
a pair of holes for the bunk location. Attach the bunk brackets to the
cross members using 3/8” x 1” carriage bolts, lock washers and hex
nuts. Hand tighten only because they will have to be adjusted when
the boat is placed on the trailer.
Position the bunks so that they are above the bunk brackets just
installed. Note that the mounting brackets attached to the bunks
are not centered on the bunks but are off center 4 inches. They
can be installed either direction. Positioning them so the extra bunk
is to the rear will allow you to put a longer boat on the trailer. This
adjustment may also be critical when trying to establish the correct
tongue weight.
Attach the bunks to the brackets using 3/8” x 1” carriage bolts and
flange lock nuts. Tighten but do not over tighten, the bunks must be
allowed to pivot so they will conform to the boat when it is placed
on the trailer.