Safety instructions – ShoreLand'r SLB95TAL User Manual

Page 7

Midwest Industries, Inc.

Ida Grove, IA 51445

800.859.3028

www.shorelandr.com

0002875

Page 7

REV B 11/02/05

��

��

Winch Assembly:

Refer to page 6 for winch parts diagram.

The winch post assembly comes factory assembled

and ready to mount on the tongue. Position the winch

assembly on the tongue in a location that would best

ﬁt your watercraft. Using four (4) 5/8” X 5-3/4” X 6-3/4”

stainless steel square u-bolts, secure the winch as-

sembly to the tongue. Tighten with 5/8” stainless steel

lock nuts so that the winch assembly will not slide on

tongue. Refer to winch adjustments on page 14.

Refer to your

Owner’s Guide and other decals on

trailer for additional information.

SAFETY INSTRUCTIONS

4810709

Before towing, check the following to
ensure that:
1. All parts, bolts, nuts and wheel

lugnuts are tight.

2. Tiedowns, winch strap and

bow-eye safety chain are secure.

3. Tires are inflated to manufacturer’s

standards.

(see tire sidewall)

4. Wheel bearings have adequate

grease.

5. Trailer coupler and coupler ball

are the same size.

6. Coupler is properly attached and

secured to coupler ball.

7. Trailer safety chains are crossed

under the tongue and attached to

towing vehicle.

8. All lights are operational.

Note: It is recommended that the

trailer lights be disconnected before

backing into the water.

9. Trailer tongue jack is in up or

travel position.

Proper tongue weight must be maintained.

Rev A 3/23/05