ShoreLand'r RB2313LW - Manual (Page 5)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003404
Page 5 REV A 9/07/06
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame, remove parts and
sort by size.
TONGUE
The tongue is shipped separate of the frame. Locate the
appropriate tongue and install by sliding it in the front of the
tongue channel.
Line the holes in the tongue with the holes in the tongue
channel. Install the 1/2” x 4” hex bolt in the front cross hole
and secure with a 1/2” lock nut.
Remove the wire harness from the rear of the tongue. Place
the wire harness and the brake line (If equipped with brakes)
through the hole provided in the tongue cover plate.
Secure the tongue cover plate in position with the same
1/2” x 1-1/2” hex bolt that secures the back on the
tongue to the tongue channel of the frame. Secure with
a 1/2” lock nut. Tighten both bolts just installed.
Plug the tongue wire harness ends into the frame
harnesses by matching colors and ends. Push the extra
wire provided either into the rear of the tongue or else
remove the grommets in the side frames and place the
extra wire in the side frame. Replace grommets just
removed.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2”
flat washer, then place through the last link of one of the
safety chains.
Place the bolt with chain attached through the hole
provided in the bottom front of the actuator mount on the
tongue. Place the second chain on the portion of the bolt
extending through the other side of the tongue. Place on
another 1/2” flat washer and hex lock nut. Tighten.
Refer to your ShoreLand’r Owner’s
Guide and other decals on trailer for
additional information.
SAFETY INSTRUCTIONS
4810709
Proper tongue weight must be maintained.
Rev C 8/28/06
Before towing, check the following to ensure
that:
1. All parts, bolts, nuts and wheel lug nuts
are tight.
2. All wheel lug nuts must be tightened to a
minimum torque rating of 85 ft/lb.
3. Lug nuts must be re-torqued after the
first 50 miles, then periodically thereafter.
4. Tires are inflated to manufacturer’s
standards. (See tire sidewall)
5. Wheel bearings have adequate grease.
6. Trailer coupler and coupler ball are the
same size.
7. Hitch ball has a rating that is equal to or
greater than the coupler or actuator
GVWR.
8. Coupler is properly attached and
secured to coupler ball.
9. Trailer safety chains are crossed under
the tongue and attached to towing
vehicle.
10. All lights are operational. Note: It is
recommended that the trailer lights be
disconnected before backing into the
water.
11. Tie downs, winch strap and bow-
eye safety chain are secure.
12. Trailer tongue jack is in up or travel
position.