ShoreLand'r LEXR22CSW - Manual (Page 11)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003295
Page 11 REV B 2/24/06
SPRINGS
Position the axle so it is properly aligned with the trailer. Place the
springs on the topside of the spring pads welded to the axle. (See
Diagram D). Note that the hook end of the spring must be mounted
to the rear of the trailer. Place a spring clamp on the top center of
the spring as shown. Next place the 1/2” x 6-1/2” U-bolts down over
the top of the spring clamp, spring and axle as shown.
Place the spring and axle U-bolt plate onto the ends of the two U-
bolts just placed. Secure in place with 1/2” lock nuts. Thread onto
the U-bolts but do not tighten securely until the complete unit is in
position on the trailer. Repeat on the other spring.
AXLE
Place one of the spring bracket bushings into the rear of the spring
bracket and secure with a 9/16” x 3-1/4” hex bolt and hex lock nut.
Repeat in other spring bracket.
Position the axle under the frame, then hook the hook loop of the
spring around the bushings just installed. Note that if the axle is
positioned too low when trying to hook, the hooks will not hook
around the bushings.
Raise the front of the springs up so they align with the front hole
of the spring bracket. Secure in place with 9/16” x 3-1/4” hex bolts
and lock nuts.
Tighten all axle U-bolts and spring bolts not tightened at this
time.
TIRE & WHEEL ASSEMBLIES
Mount the tire and wheel assemblies using the 1/2” fine threaded
tapered lug nuts provided. Tighten to 80-90 ft/lb. of torque using the
rotation pattern as shown in the ShoreLandr’s Owners Manual.
Re-torque the lug nuts after 50 miles of driving and then periodi-
cally thereafter.
Tire Size and Carrying Capacity Chart
Tire Size ST215/75R 14-C
GVWR 2995 lb.
Carrying Capacity 2300 lb.
Axle Non-Brake
Refer to the tire side wall for correct tire pressure.
XR SERIES
The XR-Series rear roller rack is installed by placing the roller arm
assembly mounting channel over the rear cross member and se-
curing in place with a 1/2” x 4-1/2” hex bolt and lock nut. (See Dia-
gram A). Note that it should be left loose until the boat is placed
on the trailer. Repeat on the other roller arm assembly. Once the
proper location is determined, it may be tightened.
Recommended carrying capacity is based on shipping weight
of the trailer with standard equipment. Adding optional equip-
ment may decrease the trailer’s carrying capacity.