ShoreLand'r LER46TCBL - Manual (Page 4)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003487
REV A 2/22/06 Page 4
FINAL ASSEMBLY INSTRUCTIONS
Remove the hardware bag from the frame. Remove the parts and sort
by size.
TONGUE
The tongue is shipped separate of the frame. Locate the
appropriate tongue and install by sliding it in the front of the
tongue channel.
Line the holes in the tongue with the holes in the tongue channel.
Install the 1/2” x 4” hex bolt in the front cross hole and secure
with a 1/2” lock nut.
Remove the wire harness from the rear of the tongue. Place the
wire harness and the brake line (If equipped with brakes) through
the hole provided in the tongue cover plate. (See Detail F).
Secure the tongue cover plate in position with the same 1/2” x
1-1/2” hex bolt that secures the back on the tongue to the tongue
channel of the frame. Secure with a 1/2” lock nut. Tighten both
bolts just installed.
Plug the tongue wire harness ends into the frame harnesses by
matching colors and ends. Push the extra wire provided either
into the rear of the tongue or else remove the grommet in the
side frame and place the extra wire in the side frame. Replace
grommet just removed.
Attach the white ground wire to the frame with a self-tapping
screw (provided) in the hole in the rear of the tongue channel
support strap.
Locate the brass brake line coupling. Remove the plastic cap and
thread the brake line coming out the rear of the tongue into one end of
the coupling. Bend the line in a smooth gradual radius being careful not
to kink the line. Bend so it can be mated to the brake line from the side
frame. Once aligned thread the side frame brake line into the other end
of the coupling. Tighten both lines into the coupling.
SAFETY CHAINS
Locate the 1/2” x 5” hex bolt. Slip the bolt through a 1/2” flat wash-
er, then place through the last link of one of the safety chains
provided.
Place the bolt with chain attached through the hole provided in the
bottom front of the actuator mount on the tongue. Place the second
chain on the portion of the bolt extending through the other side of the
tongue. Place on another 1/2” flat washer and hex lock nut. Tighten.
WINCH POST ASSEMBLY
The height that the bow eye is placed in your boat will determine
the length winch post required. Once this is determined,
attach the winch base to the tongue with three 1/2” x 4-1/2”
carriage bolts and lock nuts.
Align the holes in the Profile 2000 mounting channel with the holes in the
top of the winch base. Attach the front of the winch head mounting channel
to the base by placing a 1/2” x 4-1/2” hex bolt through the hole closest to
the front of the winch base. Secure with a lock nut. Do not tighten.
Note that the winch head can now be rotated either up or down. Identify
the correct hole combination to use to position the bow eye roller just
above the bow eye of your boat. When determined, secure in this posi-
tion by placing the bushing as shown in Detail J inside the winch base
so it aligns with the hole just identified for the proper adjustment.
Insert another 1/2” x 4-1/2” hex bolt through the determined mounting
hole in the mounting channel and winch base making sure the bolt
passes through the bushing as well. Secure with a 1/2” lock nut. Tight-
en all bolts.
Diagram B
67287-_ _