Ericsson LBI-38965B User Manual
Page 32

LBI-38965
INSTALLATION
32
USER ACTION: If either of the previous commands were executed, you can verify them by entering the
following command. The previous two steps may be repeated in case the values were incorrectly entered by the
operator.
BCS> show system /nim /pim
NIM slot = 32
PIM slot = 16
USER ACTION: Exit BCS, which returns the operator the pSH+> prompt.
BCS> exit
pSH+>
4.2.2.2. System Disk Booting
After software has been installed on the BCU/CAL system disk, the BCU/CAL will use these files for any subsequent
(re)boot. The following example shows the typical console output observed when the BCU/CAL boots from its hard disk.
No user action is required for this process. The BCU/CAL will immediately begin normal application processing when the
boot cycle is complete.
Setting IP address: 147.117.37.226 (0x937525E2)
Assigning host name: bcu01
Setting subnet mask: 0xFFFFF000