ShoreLand'r LEB40TCBBLW V.2 - Manual (Page 13)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003287
REV C 1/02/07 Page 3
B-SERIES BUNK ASSEMBLY
Locate the two short and two long 2 x 6 bunk assemblies. The long
bunks are to be mounted to the inside of the rear mounting arms
and attach to the front cross member with the brackets provided
while the short bunks will attach to the rear mounting arm only.
(See Diagram A on page 2). Note that the bunk mounting brackets
are assembled to the bunks at the factory. Place the end of the
long bunk assemblies with the two brackets towards the rear of the
trailer. Place the assembly on the equiload bunk arm and secure
by placing a 3/8” x ” hex bolt through the bracket on the bunk and
the ear on the end of the equiload arm. Secure in place using a 3/8”
lock nut. Repeat on the other end of the arm. (See Diagram A). Do
not tighten until assembly is complete.
Place the other end of the bunk in the bracket installed on the front
cross member. Note that this bracket is not attached to the bunk
because the trailer can be adjusted to two different lengths. Once
the proper position for the rear cross member is determined, the
front of the bunk can now be attached to the bracket using two- No.
0 x -/4” self tapping screws as shown in Detail C.
Attach the two short bunk assemblies to the outside of the rear
equiload arms using 3/8” x ” hex bolts similar to the long inside
bunks.
The 3/8”x ” bolts attaching the bunks to the equiload arms and
front bunk bracket can be tightened but not over tightened be-
cause the bunks should be allowed to rotate slightly to con-
form to the boat bottom once the boat is set on the trailer.
Roller Arm Assembly