ShoreLand'r B2313SW - Manual (Page 9)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003397
Page 9 REV A 8/30/06
B-SERIES BUNK ASSEMBLY
Locate the two 2 x 6 bunk assemblies. Note that the bunk
mounting brackets are assembled to the bunks at the
factory. Place the end with the two brackets towards the
rear of the trailer. Place the assembly on the equiload bunk
arm and secure by placing a 3/8” x 1” hex bolt through
the bracket on the bunk and the ear on the end of the
equiload arm. Secure in place using a 3/8” lock nut. Repeat
on the other end of the arm. (See Diagram A).
Place the other end of the bunk in the bracket installed on
the front cross member. Note that this bracket is not at-
tached to the bunk because the trailer can be adjusted to two
different lengths. Once the proper position for the rear cross
member is determined, the front of the bunk can now be
attached to the bracket using two- No. 10 x 1-1/4” self
tapping screws as shown in Detail B.
The 3/8” x 1” bolts attaching the bunks to the equiload arms
and front bunk bracket can be tightened but not over tightened
because the bunks should be allowed to rotate slightly to con-
form to the boat bottom once the boat is set on the trailer.