ShoreLand'r B2313L - Manual (Page 3)

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com
0003382
Page 3 REV A 8/29/06
Place the bolt with chain attached through the hole
provided in the bottom front of the actuator mount on
the tongue. Place the second chain on the portion of
the bolt extending through the other side of the tongue.
Place on another 1/2” flat washer and hex lock nut.
Tighten.
Refer to your ShoreLand’r Owner’s
Guide and other decals on trailer for
additional information.
SAFETY INSTRUCTIONS
4810709
Proper tongue weight must be maintained.
Rev C 8/28/06
Before towing, check the following to ensure
that:
1. All parts, bolts, nuts and wheel lug nuts
are tight.
2. All wheel lug nuts must be tightened to a
minimum torque rating of 85 ft/lb.
3. Lug nuts must be re-torqued after the
first 50 miles, then periodically thereafter.
4. Tires are inflated to manufacturer’s
standards. (See tire sidewall)
5. Wheel bearings have adequate grease.
6. Trailer coupler and coupler ball are the
same size.
7. Hitch ball has a rating that is equal to or
greater than the coupler or actuator
GVWR.
8. Coupler is properly attached and
secured to coupler ball.
9. Trailer safety chains are crossed under
the tongue and attached to towing
vehicle.
10. All lights are operational. Note: It is
recommended that the trailer lights be
disconnected before backing into the
water.
11. Tie downs, winch strap and bow-
eye safety chain are secure.
12. Trailer tongue jack is in up or travel
position.