ShoreLand'r 700SP - Manual (Page 4)

Made in the USA Midwest Industries, Inc. Ida Grove, IA 51445 (800)859-3028 0002793
www.shorelandr.com REV A - 8/17/00
Assembly should be complete except for tightening some of
the bolts. These bolts were left loose to aid in adjusting the
trailer to the boat only. All bolts and nuts must be tightened
before towing.
NOTE: The law requires that the white ground wire on both
the tongue wire harness and vehicle harness be properly
grounded to the respective trailer and vehicle frames.
ADJUSTMENT INSTRUCTIONS
Bunk Adjustment:
Place your boat on the trailer.
Determine the spacing on the bunks. It may be necessary to adjust
your bunks either further in or out from the position you have it
assembled. They must be adjusted to miss any keel or strake
which might be on your particular water craft.
IMPORTANT:
The bunks should be spaced as far apart as possible for stability.
This in most cases will also allow your water craft to be as low as
possible on the trailer for better trailering, loading and unloading.
NOTE: The rear tie-down straps are not provided with the trailer.
NOTE: Check all fasteners and tighten before towing.