HEIDENHAIN ND 520 - Manual (Page 6)

Operating Parameters
User Parameters User Parameters User Parameters User Parameters User Parameters
User parameters are operating parameters that can be changed without
without without without without entering
the codes: P00 to P25
Axis assignment
Axis-specific parameters (those requiring separate entries for each axis) have axis
codes:
1 for the X axis, 2 for the Y axis, and 3 for the Z axis.
The axis code is separated from the parameter number by a point.
In the operating parameter list, these parameters are set off with a superscript "
A " and
the parameter for the X axis is given (e.g., ).
You select axis-specific operating parameters with the orange axis keys.
To access the operating parameters:
➤ Press MOD
To go directly to an operating parameter:
➤ Press and hold CL and press the first digit of the parameter number
➤ Release both keys and enter the second digit of the parameter number
To page through the operating parameters:
➤ Page forward: press MOD
➤ Page backward: press 1 / 2
Any changes made are automatically activated when you resume paging.
To change a parameter setting:
➤ Change the setting with the minus key, or
➤ Enter the desired value directly, e.g. for P25
To correct an entry:
➤ Press CL
To exit the operating parameters:
➤ Press ENT
This activates all changes you made.
Operating Parameter List
Parameter Meaning Function / Effect Setting
Code Number 95148: protected operating parameter
105296: select compensation value table
Unit of Dimensions in mm
measurement Dimensions in inch
Radius-/diameter Radius
display A Diameter
Scaling factor Scaling factor active
Scaling Scaling factor inactive
Scaling factor A Enter a value for each axis separately
0,1
≤
P12
≤
9,999 999
Tool diameter Enter the tool diameter
Tool 0
≤
P25
≤
199,999 [mm]