Maintenance, Engine oil – Polaris 2013 Ranger 800 Midsize User Manual
Page 48
46
MAINTENANCE
Engine Oil
Always check and change the engine oil at the intervals outlined in the Periodic Maintenance
Chart beginning on page 43. Always change the oil filter whenever changing oil.
WARNING! Vehicle operation with insufficient, deteriorated, or contaminated engine oil will cause
accelerated wear and may result in engine seizure, accident, and injury. Always perform the
maintenance procedures as outlined in the Periodic Maintenance Chart.
Oil Recommendations
POLARIS recommends the use of POLARIS PS-4 PLUS Performance Synthetic 2W-50 4-
cycle oil or a similar oil. See page 76 for the part numbers of POLARIS products.
NOTICE: Mixing brands or using a non-recommended oil may cause serious engine damage. Always
use the recommended oil. Never substitute or mix oil brands.
Oil Check
The oil tank is located under the seat.
1. Position the vehicle on a level surface. Place the trans-
mission in PARK.
2. Remove the seat. See page 20.
3. Lift the lever lock to remove the dipstick. Wipe it dry
with a clean cloth.
4. Reinstall the dipstick completely, but do not lock it. The
dipstick must be screwed completely in to keep the angle
and depth of the stick consistent.
5. Remove the dipstick and check the oil level. Maintain
the oil level in the safe range. Do not overfill.
Tip: Due to the dipstick entry angle into the crankcase, the oil level
will read higher on the bottom side of the dipstick. Always read
the level on the upper surface of the dipstick.
6. After reinstalling the dipstick, be sure to seat the lever
lock.
7. Reinstall
the seat.
Safe
{
Safe
Range
Check Level
on Top Side
Dipstick
Add