Polaris 2011 Widetrak IQ - Manual (Page 125)

121
MAINTENANCE
Clutch System
Drive Belt Installation
1. Drop the drive belt over the drive
clutch and pull back the slack. The
belt cord line should be flush with,
or slightly above, the outer circum-
ference of the driven clutch sheaves.
The belt will seat itself in the driven
clutch during the break-in period.
Adjust the belt ride-out after the
break-in period by readjusting belt
deflection.
Tip: To ensure satisfactory belt life, install belts so they operate in the same
direction of rotation by positioning the identification numbers so that you
can read them. If required, separate the sheaves as outlined in the belt
removal procedures.
2. Rotate the L-wrench counter-clockwise to tighten the sheaves while
working the belt to the outer edge of the sheaves.
3. Remove the wrench.
4. Reinstall the side panel.
5. Close and secure the hood.
6. Break in the new belt. See page 68.