Polaris 2004 Victory Kingpin - Manual (Page 65)

63
OPERATION
Engine Break-in Period
Fueling and Fill Height
Fuel the motorcycle with the sidestand down and on level ground. Use only the recommended fuel (see Fuel
Specifications on page 151). Fill the fuel tank to a level just below the bottom of the fuel filler insert.
• Do not allow gasoline to come into contact with a hot engine or exhaust system. This could cause
a fire. Immediately wipe, or rinse with water, gasoline spilled on any part of the motorcycle or
the surrounding area.
• Do not fill the fuel tank above the fuel filler insert. Overfilling the fuel tank may cause fuel to
overflow when it expands.
• Fuel may leak from an improperly seated fuel cap. Be sure the fuel cap properly seated and
locked before starting the engine.
WARNING
Fuel can damage painted surfaces and plastic parts. Wipe spilled fuel immediately from the motorcycle
using a clean, dry, soft cloth.
Caution
Fuel System Priming Procedure (Out of Gas)
Notice If the motorcycle has run completely out of fuel, cycle the fuel pump 4-5 times to prime the system before
starting the engine. To cycle the fuel pump, set the ignition switch to the ON position and toggle the engine stop/run
switch from the STOP position to the RUN position 4-5 times. Wait a few seconds in the RUN position between cycles.