Polaris 2002 Victory Touring Cruiser - Manual (Page 125)

Maintenance
111
Remove and Install Saddlebags
1. Remove the lower saddlebag mounting screw located outside and underneath the saddlebag.
2. Remove the two (2) upper saddlebag mounting screws located inside the saddlebag.
3. Disconnect the wiring harness and remove the saddlebag.
4. To reinstall the saddlebag, reconnect the wire harness and install all spacers and fasteners in their
original location.
Torque: 18 ft--lbs (25 Nm)
Sidestand
Straddle the motorcycle and bring it to a vertical position. Move the sidestand to its stored (up) position, then
to its fully extended (down) position, and back again. It should move smoothly and quietly. When the
sidestand is in its stored position, the sidestand return spring should hold the sidestand tightly against the
motorcycle.
If the sidestand is bent, it should be replaced immediately.
Do not try to straighten a bent sidestand. The sidestand will be weakened, and may not be able to support
the motorcycle.
Caution
Lubricate Sidestand
1. Bring the motorcycle to a vertical position with an appropriate motorcycle lift or a block of wood or
steel placed securely under the frame.