beautypg.com

Maintenance, Cleaning and storage – Polaris 2014 ATV Sportsman X2 550 EPS User Manual

Page 144

background image

142

MAINTENANCE

Cleaning and Storage

Storage Tips

Fog the Engine

1. After stabilizing the fuel, remove the spark plugs and add 2-3

tablespoons of engine oil. To access the plug holes, use a section of
clear 1/4" hose and a small plastic squeeze bottle filled with the pre-
measured amount of oil.

2. Reinstall the spark plugs. Torque to specification.

3. Apply dielectric grease to the inside of each spark plug cap and

reinstall the caps onto the plugs.

4. Turn the engine over several times. Oil will be forced in and around

the piston rings and ring lands, coating the cylinder with a
protective film of fresh oil.

5. If POLARIS fuel system additive is not used, the fuel tank, fuel

lines, and injectors should be completely drained of gasoline.

Air Filter / Air Box

1. Inspect and clean (or replace) the pre-cleaner and air filter. See page

116.

2. Clean the air box.

Inspect and Lubricate

Inspect all cables and lubricate all areas of the vehicle as recommended
in the Periodic Maintenance Chart beginning on page 91.

Battery Storage

See pages 131-132 for storage and charging procedures.

Storage Area/Covers

Set the tire pressure and safely support the ATV with the tires slightly
off the ground. Be sure the storage area is well ventilated. Cover the
vehicle with a genuine POLARIS cover. Do not use plastic or coated
materials. They do not allow enough ventilation to prevent
condensation, and may promote corrosion and oxidation.

This manual is related to the following products: