Polaris 2012 ATV RZR 170 - Manual (Page 81)

78
MAINTENANCE
Lights
Daytime Running Lights Lamp Replacement
If the daytime running lights do not operate, replace the lamps.
POLARIS recommends that you install replacement lamps obtained
from your authorized POLARIS dealer.
1. Disconnect the lights from the harness.
2. Remove the rubber cover from the back of the light assembly.
3. Press the lamp retainer inward and turn it counter-clockwise to
remove it. Note the position of the lamp positioning tab, then care-
fully pull the lamp out.
4. Install the new lamp. Make sure the filament is horizontal.
5. Reinstall the lamp retainer. Press the retainer inward and turn it
clockwise about 1/4 turn.
6. Start the engine to make sure the lights come on. If the lights do not
operate, see your POLARIS dealer for service.
7. Reinstall the rubber cover, and reconnect the lights to the harness.
Tail Light Lamp Replacement
If the brakelight doesn't work, the
lamp may need to be replaced.
1. Remove the two screws
securing the lens cover.
Remove the lens cover.
2. Remove the lamp and replace
it with a new recommended
lamp.
3. Test the light for proper oper-
ation.
4. Reinstall the lens cover.
Screws
Cover
Lamp