Grass Valley RSAT1 - Manual (Page 8)

Satellite Panel RSAT1 1. General
Operating Instructions - Rev. 3 / 7.2002 3
1.3 OPTIONS (INITIAL ORDER ONLY)
Fader Lever (T-Bar, factory configured). For remote control on fader functions (e.g.
Timeline-, Transition- or DVE- sequence control) it is recommended to have a Fa-
der module built–in at the factory. Fader functions learnable.
Bottom side connectors (DC & 9 pin). In case the RSAT1 panel shall be used in a
rack environment we recommend this basic factory re-configuration. DC and serial
9 pin connectors are on the bottom. Also DIY configurable at a later date.
Port re-configuration for RS-232 interface. A factory reconfiguration as RS-232
port is recommended for use of an RSAT1 with a PC etc. (initial option is free of
charge). The flexible concept would allow for usage in other applications (com-
mands not yet supported by DD35 system).
1.4 FURTHER OPTIONS
RS-422 cable for standard configuration, 6m
Standard RS422 cable recommended for connection of RSAT1 to a RPD35 main
control panel. Not part of basic RSAT1 unit.
RS-232 cable (for re-configured port), 6 m
Ext. Power Supply block (with Euro plug)
Wide AC range power supply block (90 – 264V, ca.15W).
Plug-In Adaptors for USA, UK, Australia are included.
RC 2303
0 351 760 300
RC 2309
0 351 760 900
RC 2311
0 351 761 100
RC 2310
0 351 761 000
RC 2312
0 351 761 200
RC 2313
0 351 761 300