Grass Valley RSAT1 - Manual (Page 18)

Satellite Panel RSAT1 4. Operation
Operating Instructions - Rev. 3 / 7.2002 13
4. OPERATION
4.1 HOW TO START THE SATELLITE PANEL
To start the protocol for the satellite panel use the sidepanel menu. Step into the
install / panel / satpanel menu and select the port number and the type (satpanel)
of the protocol.
After that the signal light of the satellite panel has to be out. If it so, the Satellite
Panel is alive. But if you do not have a macro file in your appli_cp.ini file the satellite
panel will be without any function. To add now the filename into the appli_cp.ini
use the file transfer program FTP to get the current appli_cp.ini and insert at the
[SAT_PANEL] under
filename = ”....”
the filename of the macro including the whole path.
E.g. filename = ”/flash/satpanel/me3key1.sat” .
After the modification of the appli_cp.ini copy the file via FTP back into the mixer.
Now you should see the new function on the satellite panel.
After each new boot the file will be started automatically.