Grass Valley T2 Classic iDDR Remote Control SP1 - Manual (Page 8)

T2 ― User Manual ― Remote Control(SP1) ― 8
Section 1 ― Remote Control
rewind •
fast fwd •
cue start/end •
eject •
preview •
cue next/prev event •
VAR playback •
Active •
High •
Low •
* If the operation corresponding to the input trigger cannot be executed,
nothing happens.
* Regardless of the operation mode or lock status of the GUI, GPI inputs
can be received.
* When remote-controlling T2, do not use RS422 and GPI simultaneously.
Doing so may disable RS422 controls.
5 GPI output
Via the GPI output port (6 pins), triggers are output according to the •
T2 operation.
Output Pin settings can be specified on the setting dialog, displayed
by pressing the Config button and choosing GPI, while output Trigger
settings can be specified on the setting dialog, displayed by right-
clicking on an event list, and choosing Properties > GPI.
* The procedures in the Workstation mode are explained here.
* GPI output can be output only when issued from content loaded on
the P1 channel.