Grass Valley T2 Classic iDDR Remote Control SP1 - Manual (Page 5)

T2 ― User Manual ― Remote Control(SP1) ― 5
Remote Control
Overview
With the remote controls of the T2, the following controls and actions are
available.
As a device, T2 receives commands input via the REMOTE RS422 port •
on the T2 rear panel.
T2 controls external devices with the commands output via the
•
REMOTE RS422 port on the T2 rear panel.
As a device, T2 receives commands input via Ethernet.
•
T2 controls external devices with commands output via Ethernet. •
T2 supports BVW protocol partially (RS422 only). •
T2 supports AMP protocol partially (Ethernet only). •
According to the GPI input, the corresponding actions are performed. •
According to the Playlist > Event settings, the corresponding GPI •
triggers are output.
Recording is available in R1-Remote mode. (AMP protocol only)
•
Functions
1 R1 - VTR mode
As a controller (master), T2 controls the external device (VTR). •
When "In-Out Rec" is executed, T2 controls the VTR so as to capture •
the range between the specified timecodes.
Section
1