Grass Valley T2 Classic iDDR Remote Control SP1 - Manual (Page 6)

T2 ― User Manual ― Remote Control(SP1) ― 6
Section 1 ― Remote Control
Settings for using AMP commands
Before using the AMP commands, make sure that the network settings
have been established as below.
* The procedures in the Workstation mode are explained here.
1 Click the Config button on the T2, choose General > Network1/2 to open
the setting dialog, and set the IP address of the T2.
2 Click the Config button on the T2, choose R1 > Timecode & Remote to
open the setting dialog, and set the IP address of the connected device.
2 P1/P2 – Remote mode
As a device (slave), T2 receives the commands sent by external controllers. •
Supports BVW protocol and AMP protocol. •
* See page 11 for details on BVW commands, and page 13 for details on
AMP commands.