Grass Valley LDK 4475 Reflex SuperXpander - Manual (Page 24)

24 LDK 4475 Reflex SuperXpander User’s Guide (v1.0)
Chapter 3 - Operation
Operational indicators
Power indicator
This green indicator lights when the Reflex SuperXpander is powered by the camera.
3.2.3 Functions
The following tables provide an overview of functions included in the Reflex SuperXpander
control panel. Note that the availability of some functions depends on your camera
configuration.
Menu navigation
The Up, Down and Select buttons are used to navigate and select functions in the camera
system menu. The menu is displayed on the attached viewfinder. These buttons operate in the
same way as the Rotary and Select buttons on the front of the camera.
User functions
Three assignable user buttons (F1, F2 and F3) are provided.
To assign a function to one of the user buttons, proceed as follows:
• Push the select button on the SuperXpander’s control panel to enter the camera menu
• Go to the INSTALL > BUTTONS > SXP F1, SXP F2 or SXP F3 item and select an
assignment for that button. You can select: none, ND, FX, Bars or Prog.
Indicator Description
ND Neutral Density Filter is active on the camera.
RE Range Extender is active on the camera
RC Lights when the camera is in the remote control mode.
Utility Utility power status
Switch Default function Alternate function (with Alt)
up Menu navigation: up LED brightness higher
select Menu navigation: select Selects green, orange or indicator leds for
brightness control.
down Menu navigation: down LED brightness lower
Button Default function Alternate function (with Alt)
F1 User button F1 (assignable to: none, ND,
FX, Bars and Prog) Start diagnostic test
F2 User button F2 (assignable to: none, ND,
FX, Bars and Prog) Start diagnostic test
F3 User button F3 (assignable to: none, ND,
FX, Bars and Prog) Start diagnostic test