Grass Valley Profile Composite I/O - Manual (Page 36)

Analog Composite I/O Installation
36 Analog Composite I/O Installation
12. Install mesh washers (Figure 8) and connect analog composite input and
output cables to the Analog Composite I/O board. See Figure 9 for an
example.
Note that the S-video In connector allows you to connect an S-video device
to the Analog Composite I/O board. However, the S-video device takes the
place of one of the inputs (either In A or In B). Time Base Correction is
possible on only one input at a time.
Figure 9. Analog Composite I/O Cable Connections Example
13. Apply power to the Profile system and start the Profile Configuration
Manager application. Check the graphic representation of the Profile rear
panel. It should indicate the presence of the Analog Composite I/O board in
the slot where you installed the board.
14. Configure the system for the Analog Composite I/O board as instructed in
the Profile Family User Manual.
J1 J17 J13 J16 J15 J14 J6 J7 J4 J3 J2 J5 J12 J11 J9 J8 J10
0044-1
Video I/O
Analog Composite
S-video In
In B
Out A
Out B
In A