Example 2 – Grass Valley Profile Composite I/O User Manual

Page 26

Text mode
Original mode

Analog Composite I/O Installation

Example 2

If you next want to install an Analog Composite Monitor board:

1. From the Board I/O Requirements and Restrictions table, note that the

Analog Composite Monitor board requires four inputs and no outputs and
that the first recommended slot is J12 with slots J6, J7, and J11 as other
possibilities.

2. Looking at your Board Location Chart, you see that slot J12 is open and

although it only has 3 Inputs, the 4th Input can be the input shared with J13
because the ASPB is not using it.

3. On your Board Location Chart, put Xs in the 1, 2, and 3 J12 Input blocks and

in the J13 shared Input block.

4. Write Analog Composite Monitor in the Board column for slot J12 and

install the board.

Your Board Location Chart would then look similar to Table 4: Example 2.