Grass Valley LDK 500 - Manual (Page 63)

Operating instructions | Managing files 4-24
4.9.1 Scene files
Four scene files are stored in the camera itself (SCAM1,SCAM2, SCAM3 and SCAM4).
Another four scene files can be stored on the camera card (SCARD1, SCARD2,
SCARD3 and SCARD4). A STANDARD scene file (preselected as either factory or
customer defined) is stored in the camera.
☞
Note
The standard customer scene file is stored via the SECURITY menu, not the FILES
menu. The decision to use the factory defined file or the customer defined file as the
standard file is also made in this menu.
The FILES menu enables the scene files to be stored and recalled using the store and
recall entries of the menu system. If the message NOK is displayed, then the old values
are restored. If the camera is on-air when a scene file is recalled, then the recalled
values do not become active until the camera goes off air.
4.9.2 Operator files
The FILES menu also allows the recall of the operator file stored in the camera
(OCAM1) or one of the two operator files (OCARD1 and OCARD2) stored on the
camera card. These files contain information for setting up the non-video configuration
of the camera. A STANDARD operator files (factory or customer defined) is stored in
the camera.
☞
Note
The standard customer operator file is stored via the SECURITY menu, not the FILES
menu. The decision to use the factory defined file or the customer defined file as the
standard file is also made in this menu.
4.9.3 Standard files
The green STD button (6) on the left-front side of the camera recalls the standard
scene file. This file contains standard parameters for the picture performance. A
standard operator's file can be recalled via the
FILES menu. This file contains
parameters for the set-up of the camera.
4.9.4 Customer standard files
You can define a customer standard file for the standard scene file and for the
standard operator's file. The contents of the customer files for both these standard files
is stored via the
SECURITY menu. The selection of a factory defined or a customer
defined file for use as a standard file is also made in this menu. You can only access the
functions of the
SECURITY menu with an owner's card or the PIN code of the camera.