Grass Valley LDK 500 - Manual (Page 61)

Operating instructions | Video preferences 4-22
4. Point two small white boxes at the intended surface.
5. Press the Select button (13) to start the measurement procedure (the iris is set
to Auto). The process running message appears:
6. When the process is completed (within a few seconds) the OK message
appears in the viewfinder.
7. Adjust the skin contour level with the VIDEO\SKIN\SKIN LEVEL item.
Decrease the value below 50 to soften the selected area. Increase the value
above 50 to add extra contour.
Repeat the steps for the other memory position if required. Both skin contour settings
can be used at the same time. Set the menu item
VIDEO\SKIN\VIEW to on to
indicate the effected area.
Inverted skin
The VIDEO\SKIN menu allows you to invert the effect of the skin contours. Set this
item to on to apply the contours set up for inside the selected area to the area outside,
and the contours set up outside the selected area to the area inside.
4.8.9 Freeze frame
To assist in setting up (skin contours for example) you can freeze the current frame by
setting the Freeze frame item of the
VIDEO menu to On.
ND/RE BATT TAPE REC ++ + -
! AW2 AW1 FL 7.5 5.6 3.2
ASKIN: window
ND/RE BATT TAPE REC ++ + -
! AW2 AW1 FL 7.5 5.6 3.2
ASKIN: running