Grass Valley Kayenne K-Frame Installation Planning Guide Dec 03 2014 - Manual (Page 45)

KAYENNE K-FRAME — Installation Planning Guide 45
Network Cabling
Suites and Control Surfaces
A K-Frame system can be divided into two suites. K-Frame Video Pro-
cessor resources (MEs, eDPMs, external devices, etc.) can be assigned to
each suite, creating two switchers with one K-Frame. Each suite can be sub-
divided into two control surfaces. Each control surface is intended for use
by a single operator. The Kayenne Control Panel system flexibility permits
locating these control surfaces in physically separate locations.
Custom multi-pin cable runs are limited to 15 meters (50 ft.) If this length is
sufficient, a single PCU can be used for an entire multi-suite K-Frame
system (
Figure 3 ).
Figure 3. Two Suites with Two Control Surfaces Using One PCU
8877_04
Panel Main LAN
Eh
te
rne
t Swi
tch
1
2
3
4
5
6
7
8
Kayenne PCU
Menu
CPU
Hard
Disk
Menu
CPU
(option)
Hard
Disk
Panel
CPU
Compact
Flash
Menu Panel
Kayenne Control Panel
Local Aux Stripe
ME Stripe
ME Stripe
ME Stripe
Menu Panel
Kayenne Control Panel
ME Stripe
ME Stripe
Kayenne Satellite Panel
Satellite Stripe
Suite Boundary
Control Surface Boundary
Ethernet
Custom Multi-Pin (Menu, 15m / 50ft max length)
Custom Multi-Pin (Panel, 15m / 50ft max length)
Kayenne Satellite Panel
Satellite Stripe
Kayenne Suite 2
Suite 2
Control Surface A
Suite 2
Control Surface B
Kayenne Suite 1
Suite 1
Control Surface A
Suite 1
Control Surface B
Internal Control
K-Frame Video Processor
Video
Processor
CPU
Image Store Eh
te
rne
t Swi
tch
7
8
1
2
3
4
5
6
(Up to 8 Stripe Connections)