Eagle Electronics FISHEASY 2T - Manual (Page 25)

21
power buss. This will protect both the unit and the power cable in the
event of a short. It uses a 3-amp fuse.
CAUTION:
Do not use this product without a 3-amp fuse wired into the
power cable! Failure to use a 3-amp fuse will void your warranty.
This unit has reverse polarity protection. No damage will occur if the
power wires are reversed. However, the unit will not work until the
wires are attached correctly.
MOUNTING THE SONAR UNIT: In-Dash, Bracket or Portable
You can install the sonar unit on the top of a dash with the supplied
bracket. It can also be installed in the dash with an optional FM-4
mounting kit.
In-Dash Installation
The following figure shows dimensions for in-dash mounting. The in-
dash adapter kit includes a template for cutting the mounting hole and
complete installation directions on instruction sheet 988-0147-44.
In-dash mounting template for FishEasy 2 family, showing dimensions.
NOTE: The preceding figure is
not printed to scale. A scaled template
is available for free download from our web site, www.eaglesonar.com.
If you use the supplied gimbal bracket, you may be interested in the
optional GBSA-1 swivel bracket kit. This converts the unit's gimbal
bracket to a swivel mount which can be used on the dash or overhead
Millimeters
[Inches]
Cut on line
Top
In-Dash
Template
112
[4.40]
R 6.35
[0.25] 119
[4.68]
Hole
diameter
3.5
[0.14]
47
[1.85]
121
[4.76]
ALWAYS VERIFY DIMENSIONS