Grass Valley Fibre Channel Switch - Manual (Page 9)

29 January 2007 Fibre Channel Switch Installation Manual 9
Verify firmware version
RemoteLogHostAddress (dot-notated IP Address) [10.0.0.254]
NTPClientEnabled (True / False) [False
NTPServerAddress (dot-notated IP Address) [10.0.0.254]
EmbeddedGUIEnabled (True / False) [True]
Do you want to save and activate this system setup? (y/n): [n] y
Verify firmware version
You can use the show switch command to view switch information and confirm that
the active firmware version is correct. The minimum qualified image is:
• 5.0.0.17.0 or higher
Contact your Grass Valley representative to determine the current required version.
To view the current version information, do the following:
1. In administrator mode type the following command at the prompt:
SANbox (admin) #> show switch
2. View the switch information, an example of which is shown here. Note that the
ActiveImageVersion - build date specifies the active firmware image version and
build date.
Switch Information
------------------
SymbolicName SANbox
SwitchWWN 10:00:00:c0:dd:07:13:79
SwitchType SANbox 5202
BootVersion V1.2.0.16.0 (Mon Sep 13 15:35:12 2004)
CreditPool 0
DomainID 2 (0x2)
FirstPortAddress 020000
FlashSize - MBytes 128
LogFilterLevel Info
MaxPorts 20
NumberOfResets 6
ReasonForLastReset PowerUp
ActiveImageVersion - build date V5.0.0.17.0 (Thu Mar 10 16:11:44 2005)
PendingImageVersion - build date V5.0.0.17.0 (Thu Mar 10 16:11:44 2005)
ActiveConfiguration SANbox
AdminState Online
AdminModeActive True
BeaconOnStatus False
OperationalState Online
PrincipalSwitchRole False
BoardTemp (1) - Degrees Celsius 23
SwitchDiagnosticsStatus Passed
SwitchTemperatureStatus Normal