Grass Valley K2 Media Client Field Kit Upgrade Instruction Manual Sep.24 2007 - Manual (Page 8)

8 K2 Media Client Field Kit Upgrade Instructions August 3, 2007
K2 Media Client Field Kit Upgrade Instructions
10.Replace the codec board. Make sure screws are installed in the proper sequence,
as illustrated:
11. Replace the top cover.
12. Connect power cables.
13. Start up the K2 Media Client.
14. Log in to Windows.
15. When the AppCenter logon box appears, click Cancel and Abort .
16. Delete all configuration XML files in the C:\profile\config directory. These
configuration files cannot be saved and reused.
On restart, the K2 Media Client rescans hardware, discovers the new mezzanine
board, reconfigures appropriately, and writes a new configuration file.
17. Restart the K2 Media Client, log in to Windows and AppCenter, and open
Configuration Manager. The new channel should be available for configuration,
according to the decoder (play channel) or encoder (record channel) installed.
In addition, all settings on all channels are at the default values.
18. Configure all channels, making new settings on the new channel and returning
existing channels to their previous settings.
Loosely install
center screw 3
Install side
screws tightly 4
Tighten
center
screw 5
Install side
screws
6
Install side
screws 6
Connect large
power cable
On HD/SD models,
also connect
small power cable
7
Carefully engage the
RTP board 2
Move board into position,
then reach under and
connect XLR board cable 1