Grass Valley CameraMan Control Keypad - Manual (Page 13)

Page 10 CameraMan ® 3-CCD Camera Control Keypad Operations Manual
Operating Your Camera Control Keypad
The Camera Setup Mode buttons (with green text) on your keypad enable you to adjust the camera’s settings through four on-
screen menus. These adjustments should be made by qualified technical personnel only.
If you are using a CameraMan SHOT Director with your camera(s), you should
perform all setup through the SHOT Director. Do not use these keypad features.
Adjusting the Camera Setup Mode Settings
Setup and Mode Buttons
To enter the camera setup mode:
• Press and hold SETUP and MODE simultaneously for 2.5 seconds.
The keypad should beep once.
• Release both buttons.
• The video flashes and an on-screen menu appears when it enters the camera setup mode.
MENU EDIT Arrows
To select a setting, or the value of a setting, use the PAN/TILT MENU EDIT buttons (left/right
and up/down) on your keypad:
• TILT UP: moves the on-screen cursor up.
• TILT DOWN: moves the on-screen cursor down.
• PAN RIGHT: increases, or changes the setting.
• PAN LEFT: decreases, or changes the setting.
To change between the various on-screen settings menus:
• Place the cursor on the first line of the menu using the menu edit UP and DOWN arrows.
• Select the menu page (1-4) using the menu edit LEFT and RIGHT arrows.
For more information on the on-screen camera settings and their functionality, refer to
the 3-CCD CameraMan Installation and Operations Manual.
When accessing the on-screen camera settings, do not change the BAUD RATE. This
may impact the camera’s communication links.
MENU Button
Press the Menu button to toggle between the on-screen settings menu and the video image.
BARS Button
Press the Bars button to toggle between the on-screen color bars and the video image.
White Balance Button
Press the button next to the W to set the white balance automatically when the on-screen
menu is turned off.
Once all adjustments have been made, the camera must be returned to system mode for
normal operation. Just follow the same directions as above to enter camera setup mode. The
menu disappears and the camera returns to normal operation.
MENU button
MENU EDIT arrows
SETUP button MODE button
BARS button
WHITE BALANCE button