Grass Valley 8920MUX - Manual (Page 11)

8920MUX Instruction Manual 11
Installation
Cabling
Note At the back of every hard cover manual are overlay cards that can be placed
over the rear connector BNCs to identify the specific 8920MUX connector
functions.
Inputs
The SD video stream is connected to the looping input BNC at J9 or J10.
For balanced audio inputs, use the terminal post adapter shown in Figure 4
to connect up to two AES/EBU input sources. The adapter connects to the
plus and minus BNC pairs J5/J7 and J6/J8.
Connect unbalanced AES/EBU input BNCs to J5 and J6.
Note Jumper selections on the module must be made to select either 75 Ω unbal-
anced or 110 Ω balanced AES/EBU input (see Figure 1 on page 9 ).
Figure 4. 8920MUX Input/Output Connectors
Outputs
The 8920MUX provides four SD output streams—J1 through J4. The desti-
nation equipment should have a 75
Ω input impedance or loop-through
inputs that are terminated into 75 Ω .
J9 J10
IN
J3
J5
J7
J4
J6
J8
J2 J1
8037-02r1
Loop-through
SD Input
SD Output 1
SD Output 3
AES Input 1
unbalanced 75 Ω
SD Output 2
SD Output 4
AES Input 2
unbalanced 75
Ω
Adapter for
balanced 110
Ω
inputs, connects
to BNCs J5 - J8.
X
O
U
T
J1
J4
R+
GND
R–
L+
GND
L–
Grass Valley
Adapter
AES
Input 1
AES
Input 2