Grass Valley 2042EDA - Manual (Page 9)

2042EDA Instruction Manual 3
Installation
2. Insert the passive rear module into any vacant rear slot (1 – 12) of the
frame as illustrated in
Figure 2 .
Figure 2. Installing Passive Rear Module
3. Verify that the module connector seats properly against the midplane.
4. Using a crossblade screwdriver, tighten the two screw locks to secure
the module in the frame.
5. Install the overlay provided at the rear of this manual (hard copy only)
for input and output locations.
2042EDA Rear Module (overlay installed)
J10 SIG J9 J8 J7 J6 J5 J4 J3 J2 J1
2042EDA
In 1 Out 1A Out 1B Out 1C Out 1D In 2 Out 2A Out 2B Out 2C Out 2D
Alignment post
and receptacle Screw lock
(both sides)
8066_01
2000 frame (rear view)
Board edge guides
(both sides)