Grass Valley 2042EDA - Manual (Page 11)

2042EDA Instruction Manual 5
Installation
Cabling
Cabling to the 2042EDA module is done on the BNCs on the passive rear
module. Refer to
Figure 5 for a detailed illustration of the rear connections
referenced below.
Inputs
The 2042EDA will accept any of the video standards listed in the Input
specifications in
Table 3 on page 10 . Connect a video input to In 1, BNC J10
and In 2, BNC J5.
Outputs
The 2042EDA outputs conform to the video standards listed in the Output
specifications in
Table 3 on page 10 .
Connect video destinations to the four outputs for In 1 at Out 1A – Out 1D
(BNCs J9 – J6 respectively) and the four outputs for In 2 at Out 2A– Out 2D
(BNCs J4 – J1 respectively). Terminate any unused outputs.
Figure 5. 2042EDA Input/Output Connectors (with overlay installed)
8066_02
J10 SIG J9 J8 J7 J6 J5 J4 J3 J2 J1
2042EDA In 1 In 2 Out 1A Out 1B Out 1C Out 1D Out 2A Out 2B Out 2C Out 2D
Channel 1 Outputs Channel 2 Outputs