Grass Valley 2041RDA - Manual (Page 13)

2041RDA Instruction Manual 13
Configuration
Configuration
The 2041RDA can be configured locally using on-board jumpers or
remotely using the 2000NET network interface.
The following parameter options can be set on the 2041RDA module:
• Remote control and monitoring lockout (on-board only),
• Automatic signal locking and reclocking mode,
• Reclock/Bypass mode (enabled/disabled reclocking), and
• Manual input signal selection mode (remote only).
Local On-board Module Configuration
The 2041RDA module can be configured locally using the jumpers shown
in
Figure 5 on page 14 . The CONF LED indicates status of the configuration
process.
These components perform the following:
• Jumper J24 – sets control mode for Local only or Remote and Local.
• Jumper J25 – enables or disables the reclocking function.
• CONF (configuring) LED – when on, indicates the module is initial-
izing or processing configuration information.
Remote Control Jumper
When the jumper is placed across pins 2 and 3 of jumper block J24, module
settings are changed from the on-board jumpers only. To have both Local
and Remote access, set the jumper across pins 1 and 2.