Grass Valley SFP Optical Converters - Manual (Page 15)

SFP Optical Converters—Installation Manual 15
Configuration
Configuration
Once the submodules have been installed and cabled, refer to the specific
2000 and 8900 module instruction manuals for configuration and operation
information. In most cases, the fiber inputs and outputs must be enabled
using onboard local controls or through the web page GUI.
Manuals are available on-line at no cost at this link:
http://www.thomsongrassvalley.com/docs/
From this location, select Broadcast Products , then Modular Products .
Specifications
Table 1. Optical Submodule Specifications
Parameter Value
Fiber Inputs
Connector Up to two LC
Fiber mode Single mode, 1310 nm nominal
Minimum input power -20 dBm
Input signal formats Serial digital component video conforming to the following formats:
• SMPTE 292M (1.485 Gb/s and 1.485 Gb/s/1.oo1)
• SMPTE 259M (143 Mb/s, 177 Mb/s, 270 Mb/s, 360 Mb/s)
• SMPTE 310M (MPEG to 40 Mb/s)
• SMPTE 347M (540 Mb/s)
• 4 Mbps to 1.5 Gb/s
• DVB-ASI
Fiber Outputs
Connector Up to two LC
Fiber mode Single mode, 1310 nm nominal
Output power -12 to -7.5 dBm (average @ 1310 nm)
Signal type Serial digital component video conforming to the following formats:
• SMPTE 292M (1.485 Gb/s and 1.485 Gb/s/1.oo1)
• SMPTE 259M (143 Mb/s, 177 Mb/s, 270 Mb/s, 360 Mb/s)
• SMPTE 310M (MPEG to 40 Mb/s)
• SMPTE 347M (540 Mb/s)
• 4 Mbps to 1.5 Gb/s
• DVB-ASI