Grass Valley SFP Optical Converters - Manual (Page 11)

SFP Optical Converters—Installation Manual 11
Kameleon 2000 Fiber Ready Modules
Figure 2. Installing SFP Submodule
Cabling
All cabling to the 2040RDA module sets is done on the corresponding rear
module at the back of the 2000 frame. Cabling to each of the submodule
types is described below.
Dual Optical Receiver
With a dual optical receiver (1310NM-DRL) submodule installed, one of
the optical inputs can be configured as the module input (instead of the
coax BNC).
With the submodule handle in the up position, connect an optical input to
the left (Optic 1) or right (Optic 2) side of the optical connector as shown in
Figure 3 .
Use local or remote controls to configure one of the optical inputs as the
module input as described in the instruction manual for the specific
module.
Figure 3. Dual Receiver Optical Inputs
8
269_11
Label
Handle in
up position
Arrow Indicators
8
269_12
Optic 1 (Input) Optic 2 (Input)