Grass Valley SFP Optical Converters - Manual (Page 12)

12 SFP Optical Converters—Installation Manual
Kameleon 2000 Fiber Ready Modules
Dual Optical Transmitter
With a dual optical transmitter (1310NM-DTL) submodule installed, the
output signal can be accessed from both optical outputs, Optic 1 (left) and
Optic 2 (right), in addition to the coax BNC outputs.
With the submodule handle in the up position, connect optical cables to one
or both outputs as shown in
Figure 4 .
These outputs must then be enabled with either local or remote configura-
tion controls.
Figure 4. Dual Transmitter Optical Outputs
Optical Transceiver
With the optical transceiver (1310NM-TRL) submodule installed, the
Optic 2 input (right) can be configured as the module input (instead of the
coax BNC input) and the Optic 1 output (left) can be enabled as a module
output (in addition to the coax BNC outputs).
For an optical input to the module, place the submodule handle in the up
position and connect the fiber cable to the Optic 2 input (right) as shown in
Figure 5 . Use local or remote controls to configure this as the module input.
The output signal can also be accessed from the Optic 1 (left) connector
shown in
Figure 5 . Place the submodule handle in the up position and
connect an optical cable to this output. This output must be enabled with
local or remote configuration controls.
Figure 5. Dual Transceiver Optical Input and Output
8269_13
Optic 1 (output) Optic 2 (output)
8269_14
Optic 1 (output) Optic 2 (input)